DIY Window Installation Troubleshooting in Edmonton, AB
Your satisfaction with your Pella windows and doors is our priority. Should you have a problem with your Pella product that you think could be related to the window’s installation, trying the following steps could help determine if the product is installed level, square and plumb.
First, grab a level and put it on the frame of the product, across the bottom or sill. Do not set it on the sashes or panels of the product as it may produce an inaccurate reading. The bubble of your level should rest in the center, demonstrating the product is installed level.
Next, test plumb of your window or door. Plumb means the window or door is straight down or up, vertically. To test for plumb, put your level on the two vertical side jambs on the exterior face to ensure the product is plumb from the inside out. Next, you’ll check for plumb from left to right by placing the level on each of the two sides. The bubble should fall in the midpoint on both sides, representing that the product is installed plumb.
Third, you can check for bowing by measuring the unit horizontally across the top, middle and bottom. The measurements of these three places should all be equal, plus or minus one eighth of an inch. It’s important to always measure to and from the same point on both sides for consistency. Finally, determind if your window or door is square by measuring from corner to corner in an X fashion on the outside of the product. The measurements should be within 1/8 inch of each other, indicating the product is installed square.
You could also check the reveal, where the sash meets the frame. The gap should appear the same from top to bottom and left to right. Every side of your product should appear the same, indicating the product is installed level, square, and plumb.
Doing a little troubleshooting on your own can offer helpful information to solve a problem. If you find that you have found one, or even a couple, of these issues, stop by the Pella Window and Door Showroom in Edmonton or give us a call at 780-439-9344.